This site uses cookies.
Some of these cookies are essential to the operation of the site,
while others help to improve your experience by providing insights into how the site is being used.
For more information, please see the ProZ.com privacy policy.
Freelance translator and/or interpreter, Verified site user
Data security
This person has a SecurePRO™ card. Because this person is not a ProZ.com Plus subscriber, to view his or her SecurePRO™ card you must be a ProZ.com Business member or Plus subscriber.
Affiliations
This person is not affiliated with any business or Blue Board record at ProZ.com.
Services
Translation
Expertise
Specializes in:
Electronics / Elect Eng
Computers: Software
Telecom(munications)
Computers (general)
Computers: Hardware
Computers: Systems, Networks
Law (general)
IT (Information Technology)
Mechanics / Mech Engineering
Rates
English to Polish - Standard rate: 0.04 USD per word / 10 USD per hour
Source text - English 4 - SET POINT REGULATION
The charge of the helicoidal spring can be regulated by means of the bush (for adjustment) in such a way that the switch is released when the temperature reaches (increasing or decreasing) the desired value (set point). The instrument is usually supplied with the switches set at 0°C or at the lowest setting range value if this is higher than 0°C (factory calibration). The instrument is supplied with an adhesive rating plate showing the set point calibration value. With factory calibration the values are not indicated on the ratings as these are temporary and will be modified with the definitive values. Prior to installation the
instrument must be calibrated and the definitive calibration values written on the adhesive rating plate using a suitable indelible ink pen.
Translation - Polish 4 – REGULACJA WARTOŚCI ZADANYCH.
Naprężenie spręży reguluje się za pomocą odpowiedniego wkrętaka (regulacyjnego) tak aby wyłącznik włączył się po osiągnięciu zadanej wartości temperatury (wartości progowej). Przyrząd dostarcza się zwykle z nastawą temperatury 0°C lub na najmniejszą z możliwej z zakresu pracy temperatury, jeżeli jest ona wyższa od 0°C (ustawienie fabryczne). Urządzenie jest zaopatrzone w naklejoną tabliczkę wskazującą wartość nastawionej wartości progowej. W przypadku ustawienia fabrycznego wartość nie jest pokazywana na tabliczce jako, że jest to wartość chwilowa i może być zmieniona na konkretną wartość. Przed instalacją urządzenie musi być skalibrowane a nastawiona wartość musi zostać opisana na wspomnianej wyżej tabliczce za pomocą niezmywalnego pisaka.